3
4
Figure 18. Marking Wall Type
If it is level, the bubble of the
spirit level is positioned at the
center of both lines.
1
Table 8. Tools for Drilling
Category
Working Tools
Table 9. Anchor Bolt Drill Bits and Hole Depth
Category
CPE Outdoor
[Anchor Hole Cross Section]
[O]
35 mm
(1.4 in)
* Remove the debris from the drilled hole.
5G CPE Outdoor Installation Manual v1.0
Copyright © 2018, All Rights Reserved.
Place the mounting bracket on the fixing location, check the level status using
a level, and adjust the level of the bracket assembly.
If the level status is normal, mark the anchor bolt holes on the wall. This is
detailed in the figure below.
To drill the anchor holes
Ensure that the items mentioned in the table below are available.
Anchor Bolt
Φ 6
[X]
Chapter 2 Installing System
Unit: in. (mm)/
2.49 (64)
Description
Hammer Drill
Drill Bit (1/4 inch)
Vacuum Cleaner
Drill Bits
1/4 in. (6 mm)
(6 mm)
Confidential
Marking Point
Hole Depth
1.4 in. (35 mm)
1/4 in.
21