Please recycle or dispose of the packaging material for this product in an environmentally responsible manner. Never store or ship the air conditioner upside down or sideways to avoid damage to the compressor. The appliance is not intended for use by young children or infirm persons without supervision: Young children should be supervised to ensure that they do not play with the appliance.
Setting the Off Timer ... 13 Setting the Sleep Timer ... 14 Selecting Energy Saving mode ... 15 ECOMMENDATIONS Temperature and Humidity Ranges ... 16 Cleaning Your Air Conditioner ... 17 Solving Common Problems ... 18 Technical Specifications ... 19...
Getting Started You have just purchased a Samsung window-type room air conditioner which should be installed following your installation manual. Your Owner’s Instructions contain much valuable information on using your air conditioner. Please take the time to read them as they will help you take full advantage of the unit’s features.
Inserting the Remote Control Batteries You must insert or replace the remote control batteries when : You purchase the air conditioner The remote control does not work correctly Use two AAA, LR03 1.5V batteries. Do not use old batteries or different kinds of batteries together.
(On/Off) button. Result: The air conditioner starts up in the Cool mode. The unit beeps twice. The air conditioner is fitted with a protection mechanism to prevent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes.
The unit beeps each time you press the The air conditioner starts up in Fan mode. You can change modes at any time. When the air conditioner is in the Fan mode, the temperature cannot be set or displayed. To set the fan speed:...
(On/Off) button. Result: The air conditioner starts up in the Cool mode. The unit beeps. The air conditioner is fitted with a protection mechanism to pre- vent the unit from being damaged when it is started immediately after being: Plugged in Stopped It will start up normally after three minutes.
Adjust the air flow blades to the desired position by sliding them side to side. Adjusting the Air Flow Direction Vertically The outer air flow blades can be adjusted to control the vertical air flow direction. (Except AW0503B / AW0505B /AW0509B/ AW0603B/AW0605B/AW0609B) RECOMMENDATION When... Cooling Adjust the air flow blades to the desired position, by pushing them upwards or downwards.
The On Timer enables you to switch on the air conditioner automatically after a given time. You can select the On timer only when the air conditioner is off. You can select the On timer when the air conditioner operates in the Cool or Dry mode.
The Off Timer enables you to switch off the air conditioner automatically after a given time. You can select the Off timer only when the air conditioner is on. You can select the Off timer when the air conditioner operates in the Cool or Dry mode.
The SLEEP indicator is no longer displayed. The air conditioner operates in the mode selected last. If you select the Energy Saving mode in the Sleep Timer mode, the Sleep Timer will be cancelled and the air conditioner will start up in the Energy Saving mode.
The fan will continue to run for a short time after the compressor cycles off. If you would like the air conditioner to run in Dry mode, do not press button. You cannot use the Dry mode in the energy saving E.Saver...
Temperature and Humidity Ranges The following table indicates the temperature and humidity ranges within which the air conditioner can be used. Mode Indoor Temperature Cooling 70°F to 90°F approx. If the air conditioner is used at... Higher temperature Lower temperature...
Cleaning Your Air Conditioner Be sure to clean the air filter periodically to maintain the air conditioner in the best condition for a long period of time. When cleaning the air conditioner, turn it off and pull out the power plug.
Odors are permeating the room during air conditioning Explanation / Solution Check that the circuit breaker used for the air conditioner has not been triggered. Check that the power cable is plugged into a wall socket and the socket is switched on, if necessary.