Subscribe to Our Youtube Channel
Related Manuals for Winco UL2FS2MP-1
Summary of Contents for Winco UL2FS2MP-1
- Page 1 UL2FS2MP-1 2-BEARING GENERATOR INSTALLATION AND OPERATORS MANUAL WINCO INC. 225 S. CORDOVA AVE. LE CENTER, MN 56057 507-357-6821 SERVICE DEPT. 507-357-6831 www.wincogen.com...
-
Page 2: Table Of Contents
TABLE OF CONTENTS COPY YOUR MODEL AND SERIAL NUMBER HERE No other WINCO generator has the same serial number as yours. If you should ever need to contact us on this unit, it will help us to SAVE THESE INSTRUCTIONS respond to your needs faster. -
Page 3: Ansi Safety Definitions
ANSI SAFETY DEFINITIONS 5.SERVICING EQUIPMENT - All service, including the installation or replacement of service parts, should be performed only by a qualified technician. DANGER: DANGER indicates an imminently hazardous situation which, if not A. Use only factory approved repair parts. avoided, will result in death or serious injury. -
Page 4: Preparing The Unit
4.8 horsepower engine for full output, let WINCO take care of the freight claim. If you sign for the unit, the good speed/voltage regulation, and satisfactory load performance. -
Page 5: Connecting The Loads
CAUTION: EQUIPMENT DAMAGE: The following table shows the effect of various operating speeds and electrical loads on a typical generator when matched and mounted to Keep the generator load within the generator and receptacle nameplate an adequate prime mover. ratings. Overloading may cause damage to the generator and/or loads. Most electric tools and appliances will have the voltage and amperage LOAD VS. -
Page 6: Slip Rings
TESTING ARMATURE FOR OPENS AND GROUNDS thereafter. Remove brushes one at a time and check for length. Be sure that each move freely in the brush holder. Brushes should be replaced when worn down to 3/8”. Always replace brushes in complete 1. -
Page 7: Troubleshooting Chart
TROUBLESHOOTING CHART SYMPTOM POSSIBLE CAUSE(S) CORRECTIVE ACTION No output or low voltage. 1. Open or shorted armature. 1. Replace armature. 2. Open or grounded field coil(s). 2. Replace field coil(s). 3. Generator operating below correct RPM 3. Generator must be operated at 3600 RPM +/- 90 RPM for 4. -
Page 8: Month Limited Warranty
WINCO written instructions. WINCO’s sole liability, and Purchaser’s sole remedy for a failure under this warranty, shall be limited to the repair of the product. At WINCO’s option, material found to be defective in material or workmanship under normal use and service will be repaired or replaced.
Need help?
Do you have a question about the UL2FS2MP-1 and is the answer not in the manual?
Questions and answers