Winco HPS12000HE Installation And Operator's Manual
Hide thumbs
Also See for HPS12000HE:
- Installation and operator's manual (20 pages) ,
- Owner's manual (16 pages) ,
- Installation and operator's manual (20 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Winco HPS12000HE
Summary of Contents for Winco HPS12000HE
- Page 1 HPS12000HE/F INSTALLATION AND OPERATORS MANUAL TRI-FUEL GENERATOR...
-
Page 2: Table Of Contents
Should you experience a problem please follow the “Troubleshooting Tables” near the end of this HPS12000HE/F MODEL manual. The warranty listed in the manual describes what you can expect from WINCO should you need service assistance in the future. SERIAL NUMBER_________________________ PURCHASE DATE_________________________ TABLE OF CONTENTS... -
Page 3: Safety Information
b. Keep fuel containers out of reach of children. SAFETY INFORMATION c. Do not smoke or use open fl ame near the generator set or fuel tank. This engine generator set has been designed and d. Keep a fi re extinguisher nearby and know its manufactured to allow safe, reliable performance. -
Page 4: Unit Capabilities
GENERATOR CONNECTIONS is fully checked for performance. The generator is loaded to its full capacity, and the voltage, current HPS12000HE: 120 volt and 240 volt receptacles and frequency are carefully checked. are provided for connection to various loads. The diagram below represents this 10,800 watt (rated Rated output of generator is based on engineering output) generator. -
Page 5: Preparing The Unit
Self-exciting generators respond to severe overload- LUBRICATION ing differently than utility power. When overloaded, the engine is not able to supply enough power to Before starting the engine, fi ll the crankcase to the bring the electric motor up to operating speed. The proper level with a good quality oil. -
Page 6: Lp/Ng Installation
DANGER: FIRE - PERSONAL INJURY - installed. This optional 12 volt DC valve is available through your local Winco dealer and can be used to All fuel lines must be installed by a qualifi ed fuel shut the fuel off during normal periods of operation supplier. -
Page 7: Fuel Consumption
The fuel line used to connect the supply line to the demand regulator must be a locally approved fl exible fuel line. Products used will vary in different regions depending on availability and local codes. Consult with your local fuel supplier to ensure complete com- pliance with ALL codes. -
Page 8: Tank Sizing For Lp
CHANGING FUEL TYPES These engine generator sets are designed to run on three different fuels; gasoline, natural gas or LP vapor. They may be easily changed from one fuel to another. FROM GASOLINE TO LP/NG 1. With the engine running turn off the gasoline fuel valve. -
Page 9: Battery Installation
OIL ALERT SYSTEM This WINCO generator is equipped with a low oil shutdown system. This Honda engine uses an fl oat switch mounted inside the engine. If the oil level... -
Page 10: Initial Start Up
INITIAL START UP 4. Turn the engine switch to the “on” position Turn the engine switch to The throttle control on these generators is preset and the ON position. locked to operate at 3600 RPM (nominal) with no load speed set at 3690 RPM. Only a trained service technician should be allowed to adjust this speed setting. -
Page 11: Electric Starting For Lp/Ng
OPEN OPEN LP/NG STARTING 2. Hot weather CLOSED CLOSED MIN. MIN. Use the proper oil for the temperature MIN. MIN. expected. 1. Check oil level, refi ll as needed. Use only summer blended gasoline. Using 2. Turn on the LP/NG fuel supply gasoline left over from winter may cause the 3. -
Page 12: Connecting The Loads
All engines have a tendency to slow down when a CAUTION: EQUIPMENT DAMAGE load is applied. When the electrical load is connected to the generator, the engine is more heavily loaded, SPEED ADJUSTMENTS SHOULD ONLY BE and as a result the speed drops slightly. This slight MADE BY A QUALIFIED SERVICE TECH. -
Page 13: Wiring
It must be protected during inclement secondary emergency distribution panel may have to weather. be installed, such as the Emergency Transfer/Service (ET/S) system available through your WINCO dealer. WIRING The emergency distribution panel must be installed by a licensed electrician according to all applicable codes. -
Page 14: Engine Care
ENGINE CARE b. Remove oil drain bolt at base of the engine and drain the oil into an approved container. If major engine service or repair is required, contact c. Remove the oil fi lter and dispose of it properly. an authorized engine service center. -
Page 15: Generator Care
GENERATOR CARE AIR CLEANER COVER LATCH Proper care and maintenance of the generator is necessary to ensure a long trouble free life. AIR CLEANER COVER FOAM FILTER 1. Exercising The Generator - The generator ELEMENT WING NUT should be operated every three to four weeks. It should be operated for a period of time suffi... -
Page 16: Troubleshooting
TROUBLESHOOTING GENERATOR SPECIFICATIONS Generator manufacturer MECC Alte Spa PROBLEM (SYMPTOMS) POSSIBLE Generator model number S20FS-160A Part number 351836-1 CAUSES Rotor resistance 6.57 Ohms ——————————————————————— Stator resistance 0.124 Ohms Won’t Start *Low Oil Level. Cap winding resistance 0.60 Ohms *Fouled spark plug. Capacitors 31.5 mF *Out of fuel. -
Page 17: Control Panel Wiring Diagram
3240-10 60706-236... -
Page 18: Warranty Information
To the extent permitted by law, any and all warranties, including those of merchantability and fi tness for a particular purpose, are limited to 24 months from date of purchase. In no event is WINCO liable for inci- dental or consequential damages. -
Page 19: Warranty Statement
WINCO cannot deny warranty solely for lack of receipts. As the generator owner, you should be aware that WINCO may deny you warranty coverage if your genera- tor or a part has failed due to abuse, neglect, or improper maintenance or unapproved modifi cations. - Page 20 WINCO INC. 225 S. CORDOVA AVE. LE CENTER, MN 56057 507-357-6821 SERVICE DEPT. 507-357-6831 www.wincogen.com 3240-10 60706-236...
Need help?
Do you have a question about the HPS12000HE and is the answer not in the manual?
Questions and answers