Advertisement
Before Installing the Cooktop, Ensure:
•
The work surface is square and level, and no structural members interfere with
space requirements.
•
The work surface is made of a heat-resistant and insulated material.
•
If the cooktop is installed above an oven, the oven has a built-in cooling fan.
•
The installation will comply with all clearance requirements and applicable
standards and regulations.
•
A suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring mounted and positioned to comply
with the local wiring rules and regulations.
•
The isolating switch must be of an approved type and provide a 3mm air gap
contact separation in all poles (or in all active [phase] conductors if the local wiring
rules allow for this variation of the requirements).
•
The isolating switch is easily accessible to the customer with the cooktop installed.
•
You consult local building authorities and by-laws if in doubt regarding installation.
•
You use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
surfaces surrounding the cooktop.
After Installing the Cooktop, Ensure:
•
The power supply cable is not accessible through cupboard doors or drawers.
•
There is adequate flow of fresh air from outside the cabinetry to the base of the
cooktop.
•
If the cooktop is installed above a drawer or cupboard space, a thermal protection
barrier is installed below the base of the cooktop.
•
The isolating switch is easily accessible.
Before Locating the Fixing Brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force onto the controls protruding from the cooktop.
Adjusting the Bracket Position
Fix the cooktop on the work surface by screwing 4 brackets on the bottom of cooktop (see
picture) after installation. Adjust the bracket position to suit for different counter thicknesses.
8
Advertisement
