Kinetico Premier Compact User Manual page 11

Caution:
Do not solder any fitting while connected to the unit adaptors. Care should be
taken during the installation process to ensure solder and flux do not come in
contact with any of the components.
5
Install:
Plumb pipework as necessary to
accommodate a by-pass assembly.
Please note:
Verify installation complies with regional
water regulations before continuing. Consult
WRAS Guidance Note 09-07-01 for advice.
6
Flush:
After all the plumbing has been
completed, but before connecting
to the water softener, flush both
inlet and outlet lines allowing water
to rinse out any debris.
7
Fit in/out adapters:
a:
Fit 2 o-rings to each in/out
adaptor then lubricate with the
supplied silicone grease.
b:
Connect the inlet/outlet
adapters to the supply and
return hoses remembering to
use the screened washers.
c:
Install adapters into control
valve in/out ports, ensuring that
they are fitted into the correct
ports (see flow arrows on valve
for reference).
d: Attach the retaining bracket and
pin to the control valve.
www.kinetico.co.uk
11