Magtek iDynamo 6 Installation And Operation Manual page 40

Appendix A - Technical Specifications
Display Size (viewable area)
Display Resolution
Keypad
Ingress Protection
Tamper Protection
Code Protection
Eavesdrop Protection
Power Inputs
Battery Type
Battery Capacity
Battery Charge Time
Battery Time, Powered Off
Battery Time, Idle
Battery Time, Sleep Mode
Battery Time, Transactions
Voltage Requirements
Maximum Current Draw
Data Storage
iDynamo 6| Secure Card Reader Authenticator | Installation and Operation Manual
iDynamo 6 Technical Specifications
Not Applicable
Not Applicable
Not Applicable
Security Characteristics
Not Applicable
Tamper Evident Enclosure
Signed firmware. The device will not allow a host to install firmware
that is not properly signed by an authorized source.
Not Applicable
Electrical Characteristics
USB-C receptacle
Plus select from Lightning iAP2 plug, USB-C plug, Micro-USB B plug,
or no additional power connection
iDynamo 6: Not Applicable
iDynamo 6 with battery pack: Rechargeable Lithium Polymer (LiPo)
iDynamo 6: Not applicable
iDynamo 6 with battery pack: 400 mAh nominal, used for contactless
reader power only
iDynamo 6: Not Applicable
iDynamo 6 with battery pack: Approximately 2 to 3 hours to full charge
Up to 2 years (time from 60% charge to 0% charge)
Not Applicable
Not Applicable
Overall battery time depends on host battery capacity.
Contactless reader ~250 contactless reads per battery pack charge
USB-C, Micro-USB B: 5V
Lightning: 3.3V
From USB-C receptacle:
270 mA (connected mode with swipe/contact/contactless enabled)
Additional draw (~2A, depends on host) when charging battery pack
and/or host's battery
From connected handheld host:
86mA when magnetic read head is on; <5mA otherwise
Not Applicable
Page 40 of 41 (D998200321-20)