How To Connect To An Ios Host Using The Usb-C Plug - Magtek iDynamo 6 Installation And Operation Manual

2 - Installation
e) Before testing a swipe, use the app to
response
0000
provides an
MSR On
f) After swipe testing,
12) Optionally set up iDynamo 6 for pass-through charging as described in section 2.2 How to Use the
USB-C Receptacle for Pass-Through Charging. Specifically in the case of iDynamo 6 with
Lightning, if the USB-C receptacle is cabled to a host computer, that host may also have limited
command / response communication with the device.
To disconnect iDynamo 6 from an iOS host, follow these steps:
1) Make sure all installed apps that use iDynamo 6 are either closed or disconnected.
2) Turn off the host's display to avoid accidentally launching or interacting with apps.
3) Disconnect the cable from the USB-C receptacle, if one is connected.
4) Carefully disconnect iDynamo 6 by pulling it straight out from the host's Lightning connector.

2.5.3 How to Connect to an iOS Host Using the USB-C Plug

Details about connecting iDynamo 6 to an iOS-based host using the USB-C plug are slated for release in
a future revision of this manual.
iDynamo 6| Secure Card Reader Authenticator | Installation and Operation Manual
Send
to enable the magnetic stripe read head. For convenience, the
button that sends this command to the device with a single press.
command
Send 580100
Page 23 of 41 (D998200321-20)
command to the device and receive
580101
to disable it and conserve power.
app
MagTek Test