Appendix 2Sub System - Furuno FAR-3210 Instruction Manual

APPENDIX 2 SUB SYSTEM
To share the sensor data throughout the system, use HUB-3000 and HUB-100 and connect equip-
ment in subsystems. For example, in the configuration below, the system does not have HUB-100.
In this case the No.1 Chart radar can only receive data from the No. 2 Gyro and the No.1 ECDIS
can only receive data from the No. 1 Gyro.
No.2 Gyro
The configuration of subsystem A to Z is as shown below.
• Subsystem A: The processor units are connected to the sensor adapters through HUB-100.
• Subsystem B to Z: The processor unit is connected the sensor adapter directly.
For example, in the system configuration shown below the subsystems are arranged as follows:
• Subsystem A: No.2 chart radar, No.2 ECDIS and No.3 ECDIS
• Subsystem B: No.1 ECDIS
• Subsystem C: No.1 Chart radar
Subsystem B
Subsystem C
switch status
No.1 GYRO
Gyro Selector
No.1 No.2 GYRO
GPS
No.1 GPS
Chart radar
No.2 GPS
LOG
Sensor
adapter
Other sensors
No.1
Chart radar
Sensor network
Sensor adapter
Other sensors
Subsystem A
Contact signal
Heading
No.1 GYRO
No.2 GYRO
No.1 GPS
No.1 ECDIS
No.2 GPS
LOG
LOG
Autopilot
Sensor
adapter
Other sensors
HUB-3000
No.1 Gyro
No.1
ECDIS
Sensor network
Sensor adapter
Other sensors
HUB-3000
No.1 GYRO
No.2 GYRO
No.1 GPS
No.2 ECDIS No.3 ECDIS
No.2 GPS
LOG
HUB-100
Sensor
adapter
Other sensors Other sensors
Gyro Selector
No.2
GPS
Chart radar
LOG
Sensor
adapter
AP-3