How To Delete An Alert Group; Alert Definition Setting For Each Equipment - Furuno FAR-3210 Instruction Manual

1.8.4

How to delete an alert group

1. Click the [Delete Group] button on the [Alert Group Setting] window, referring to
the figure in step 2 of subsection 1.8.1. The list of the alert groups is shown in the
[Group Details] window.
Checkbox
2. Check the checkbox of the alert group to delete. To delete all groups, check the
"Delete All" box.
3. Click the [OK] button.
4. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.8.5

Alert Definition setting for each equipment

You can create alert definitions and activate/deactivate the alert(s) for each external
equipment or sensor.
1. Access the [Common Installation Setting] menu, then select [Alert Define List]
from the Tab bar.
2. Select the appropriate type on the menu bar. For example, select [Chart Radar]
[FAR-3xx0] to set the alert definitions for FAR-3xx0.
Note: The equipment and sensors shown on the menu bar depend on the [Instal-
lation Parameters] menu settings.
3. Set the appropriate options referring to the table shown below.
1 Equipment type
2 [Source]
3 [Data Type]
4 [New Alert] button Add a new alert definition. See section 1.8.6.
Delete All
box
Item
Selected equipment type.
Define the category to which the alert is assigned for display
in the AMS mode's alert list window ([Navigation], [Commu-
nication] or [External]).
Alert sentence format (ALF or ALR). For sensors, select the
alert notification sentence from the pull-down list.
1. INITIAL SETTING AND ADJUSTMENT
Remarks
1-45