How To Edit An Alert Group - Furuno FAR-3210 Instruction Manual

1. INITIAL SETTING AND ADJUSTMENT
3. From the [Type No.] pull-down list in the [Alert Setting] window, select the equip-
ment that handles the alert in the alert that you want to register in this group.The
alert list appearance depends on the external equipment's sentence format.
Checkbox
Checkbox
4. Check the checkbox of the alert to be set in the alert group (multiple selection pos-
sible).
Note: To unregister all alerts from the alert group, click the [Remove All Alert] but-
ton (see the figure in step 1).
5. Click the [OK] button to close the [New Group] window.
6. To set alerts for other equipment, click the [Details] button of the added alert group
(see the figure in step 2 of section 1.8.1). The [Group Details] window is shown.
7. Set the alert to the alert group with the same procedure as step 3 to step 5.
8. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1.8.3

How to edit an alert group

1. Click the [Details] button of the alert
group to edit on the [Alert Group Set-
ting] window, referring to the figure in
step 2 of section 1.8.1. The [Group
Details] window is shown.
2. Set the appropriate items in the [Group Setting] column referring to the step 2 of
section 1.8.2.
3. Select the alert to add in the alert group referring to the step 3 to step 4of
section 1.8.2.
4. Click the [OK] button to close the [Group Details] window.
5. To save the configuration, perform a consistency check, then save the configura-
tion data on the [Save and Sync] menu.
1-44
For ALR sentence
For ALF sentence
[+]/[-] button
Instance
data