Operation; Stand-Alone Operation - EuroLite LED IP Tourlight 120 WW User Manual

OPERATION

The display indicates the last operating mode. The operating modes can be selected by means of the display
and the control buttons. All settings remain stored even if the device is disconnected from the mains. The
device can be operated in stand-alone mode via the control board or in DMX-controlled mode via any
commercial DMX controller.

Stand-alone operation

Operating buttons
MODE
ENTER
UP
DOWN
Menu structure
Default highlighted in gray
Mode
DMX ADDR: 001 ~ 512
01CH
DMX Mode
03CH
SLAVE SLAVE
LED
DimMode
Halogen
Linear
Square
DimCurve
INV. Square
S-Curve
WW: 000 – 255
Manual
STR: 000 – 255
No DMX Hold / Blackout
Temp xxx °F/°C
AutoLock OFF / ON
Op.Time 000
DFSE OFF / ON
Password 000-255
FIXTURE ID
(RDM)
RDM ID 0000-9999
Selects the operating mode or returns to the initial screen.
Activates a value to be modified or saves a value when modifying.
Selects the next menu item or increases values when modifying.
Selects the previous menu item or decreases values when modifying.
Display Function
Setting DMX starting address
Setting DMX channel mode
Slave-setting
Dimmer speed 1 = LED
Dimmer speed 2 = Halogen
The increase in light intensity appears to be linear as DMX
value is increased
Light intensity control is finer at low levels and coarser at
high levels
Light intensity control is coarser at low levels and finer at
high levels
Light intensity control is fine at low levels and high levels
and coarser at medium levels
Increasing intensity 0 – 100%
Increasing speed 0 – 100%
Modes if no DMX
Inside temperature in °C or °F
Key lock activation
Fixture running time since initial start-up
Restore factory settings
Passwort: 050
(Password:UP-DOWN-UP-DOWN-ENTER)
20/24 00123337, Version 1.0