EuroLite LED IP Tourlight 120 WW User Manual page 21

Interconnecting several devices (master/slave operation)
Several devices may be interconnected (max. 32). Then all slave units can be synchronized and controlled
with the master unit without the need for a DMX controller. The devices must be set to the corresponding
operating modes.
Connect the DMX output of the master unit to the DMX input of the first slave unit. Then connect the DMX
output of the first slave unit to the DMX input of the second slave unit, etc. until all units have been
connected in a chain. Do not connect a DMX controller to the DMX input of the master unit.
Press the MODE button to select the SLAVE MODE. The devices set in this manner can now be controlled
by the master unit.
DimMode / Setting dimmer speed (step response)
The function DimMode indicates the dimmer speed, response characteristics of LEDs or response
characteristics of halogen lamps.
Dimmer Curve
With this function, you can set various dimmer curves.
LINEAR: the increase in light intensity appears to be linear as DMX value is increased.
SQUARE LAW: light intensity control is finer at low levels and coarser at high levels
INVERSE SQUARE LAW: light intensity control is coarser at low levels and finer at high levels
S-CURVE: light intensity control is fine at low levels and high levels and coarser at medium levels.
Linear
Manual
With this function you can manually set the color intensity and strobe effect speed.
No DMX
With this function, you can set different modes if there is no DMX-signal.
Blackout
The device will go Blackout, if there is no DMX-signal.
Hold
The device will hold the last received DMX-program received, if there is no DMX-signal.
Temp
With this function, you can display the inner temperature in degrees Celsius or degrees Fahrenheit.
Auto Lock
With this function, you can lock the buttons of the Control Board to e.g. prevent menu tampering. If this
function is activated, the buttons will be automatically locked in 15 seconds from the last command. In order
to deactivate or temporarily deactivate the key lock function, enter the password (see table Menu structure).
Op.Time
With this function, you can display the running time of the device. The display shows "XXX", "X" stands for
the number of hours.
21/24 00123337, Version 1.0