Parameters (Incremental Or Pulse Encoder) - Siemens SIMATIC S7-1500 Manual

4.1.3.2

Parameters (incremental or pulse encoder)

Parameters of the TM PosInput 2 with incremental or pulse encoder
The following parameter settings are possible in the hardware configuration:
Table 4- 4 Settable parameters and their default setting (incremental or pulse encoder)
Parameter
Reaction to CPU STOP
Enable diagnostic interrupt
on wire break
Enable additional diagnos-
tic interrupts
Hardware interrupt: New
Capture value available
Hardware interrupt: Syn-
chronization of the counter
by an external signal
Hardware interrupt: Gate
start
Hardware interrupt: Gate
stop
Hardware interrupt: Over-
flow (high counting limit
violated)
Hardware inter-
rupt:Underflow (low count-
ing limit violated)
Hardware interrupt: Direc-
tion reversal
Hardware interrupt: Zero
crossing
Hardware interrupt: Com-
parison event for DQ0
occurred
Hardware interrupt: Com-
parison event for DQ1
occurred
Technology module TM PosInput 2 (6ES7551-1AB00-0AB0)
Manual, 06/2018, A5E03982218-AB
4.1 Operating with "Counting and measurement" technology object
Value range
Output substitute value
•
Keep last value
•
Continue operation
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Deactivated
•
Activated
•
Configuring/address space
Default setting Parameter
reassign-
ment in
RUN
Output substitute Yes
value
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Deactivated Yes
Scope
HSP for STEP 7
(TIA Portal)
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
Channel
39