Table of Contents
Advertisement
Installation and operating instructions
QX³ series
Installation:
Field
Country selection
Power reduction
Reduction of static power to
70%
cos(phi) settings
Moving average voltage
_____________________________________________________________________________________________
Q3 ENERGIE Installation and operating instructions QX³ series
Version 1.0, Stand 27.04.2015
Function
Select the country in which your inverter is operated from the list.
Select the power reduction regulation you need for your system.
You can:
- Set no power reduction
- Set the power reduction using the ripple control receiver;
configuration takes place using a table. You
must enter the corresponding power reduction for every possible
logical combination
or for every contact here.
- Select static power reduction of 70% To do this, enter the rated
power of your
generator in the provided box.
- Select dynamic power of 70%, measurement of own consumption
via S0 interface.
- Select external control by a measurement and control module.
More information can be found in the following
Chapter "7.3.4 Power reduction".
Enter the nominal power of the PV generator here.
You grid operator has informed you of the cos(phi) correction factors
that you must set for your inverter location. Set these in the
correction table.
Set the value for the moving average voltage. You can obtain this
from your grid operator.
93/109
Advertisement
Table of Contents
