Removing The Interface Module - HPE JH182A User Manual

Figure 3 Installing the LSWM124XGT2Q interface module

Removing the interface module

CAUTION:
• Before you remove the interface module, remove the cable
from it to avoid cable damage.
• If you are not to install a new interface module,, install a filler
panel in the slot to prevent dust and ensure good ventilation in
the device.
To remove the interface module:
1. Prepare an anti-static bag.
2. Press the latch to release the ejector lever
3. Rotate outward the ejector lever, as shown by callout 1 in
4.
4. Pull the interface module slowly out of the interface module slot,
as shown by callout 2 in
5. Place the removed interface module in the anti-static bag.
Figure 4 Removing the LSWM124XGT2Q interface module
Figure 4.
7
Figure