Installing And Removing The Interface Module; Installing The Interface Module - HPE LSWM124XG2Q User Manual

Table 11 QSFP+ port LED description
LED status
Steady green
Flashing green The port is sending or receiving data at 40 Gbps.
Steady yellow
Flashing
yellow
Off
NOTE:
The SFP+ port LEDs and QSFP+ port LEDs are not affected by
the port mode switching button on your switch. For more
information about the port mode switching button, see the
installation guide of the switch.

▌Installing and removing the interface module

CAUTION:
• Before you install or remove the interface module, wear an
ESD wrist strap and make sure the strap makes good skin
contact and is reliably grounded.
• To avoid device damage, do not use excessive force when you
install or remove the interface module.
The installation and removal procedures are the same for the
LSWM124XG2Q and LSWM124XG2QL interface modules. This
section uses the LSWM124XG2Q interface module as an example.

Installing the interface module

Before you install the interface module, remove the filler panel (if any)
from the target slot. Keep the removed filler panel for future use.
Description
A transceiver module or cable has been correctly
installed. The port has a link and is operating at 40
Gbps.
A transceiver module or cable has been correctly
installed. The port has a link and is operating at 10
Gbps.
The port is sending or receiving data at 10 Gbps.
No transceiver module or cable has been installed
or no link is present on the port.
9