HPE JH182A User Manual page 5

LEDs
Table 6 describes 1/10GBASE-T autosensing Ethernet port
LEDs. Table 7 describes QSFP+ port LEDs.
Table 6 1/10GBase-T autosensing Ethernet port LED description
LED status
Steady green
Flashing green
Steady yellow
Flashing yellow
Off
Table 7 QSFP+ port LED description
LED status
Steady green
Flashing green
Steady yellow
Flashing yellow
Off
NOTE:
The 10GBASE-T port LEDs and QSFP+ port LEDs are not
affected by the port mode switching button on your switch. For
more information about the port mode switching button, see the
installation guide of the switch.
Description
The port has a link and is operating at 10 Gbps.
The port is sending or receiving data at 10 Gbps.
The port has a link and is operating at 1 Gbps.
The port is sending or receiving data at 1 Gbps.
No link is present on the port.
Description
A transceiver module or cable has been
correctly installed. The port has a link and is
operating at 40 Gbps.
The port is sending or receiving data at 40 Gbps.
A transceiver module or cable has been
correctly installed. The port has a link and is
operating at 10 Gbps.
The port is sending or receiving data at 10 Gbps.
No transceiver module or cable has been
installed or no link is present on the port.
5