Installing And Removing The Interface Module; Installing The Interface Module - HPE JH182A User Manual

▌Installing and removing the interface module

CAUTION:
• Before you install or remove the interface module, wear an
ESD wrist strap and make sure the strap makes good skin
contact and is reliably grounded.
• To avoid device damage, do not use excessive force when you
install or remove the interface module.

Installing the interface module

Before you install the interface module, remove the filler panel (if any)
from the target slot. Keep the removed filler panel for future use.
To install the interface module:
1. Unpack the interface module.
Figure 2 LSWM124XGT2Q interface module
(1) Ejector lever
2. Press the latch on the interface module to release the ejector
lever.
3. Insert the interface module slowly into the slot along the guide
rails, as shown by callout 1 in
4. Rotate inward the ejector lever until the latch locks the ejector
lever in place, as shown by callout 2 in
(2) Latch
Figure 3.
Figure
6
3.