Sale & Disposal; Owner Responsibility; Refrigeration & Electrical Data; Self Contained - FEDERAL INDUSTRIES SSRSP Series Installation & Operation Instructions

SALE & DISPOSAL

Owner Responsibility

If you sell or give away your Federal Industries case you must make sure that all safety labels and
the Installation-Service Manual are included with it. If you need replacement labels or manuals,
Federal Industries will provide them free of charge. Contact the customer service department at
Federal Industries at (800) 356-4206.
The customer service department at Federal Industries should be contacted at the time of sale or
disposal of your case so records may be kept of its new location.
If you sell or give away your Federal Industries case and you evacuate the refrigerant charge before
shipment. Federal Industries recommends that the charge be evacuated into a recovery system to
prevent the possibility of HFC's from being released into the atmosphere.
REFRIGERATION & ELECTRICAL DATA
MODEL REFRIG.
SSRSP5052
SSRSP5952
SSRSP7752
Electronic Control Operation
This unit is equipped with an Invensys – Ranco temperature control. The control parameters are
set at the factory and cannot be manually changed in the field. Control parameter changes can
only be made by downloading a new set of parameters via a program chip supplied by Federal
Industries. The pre set control parameters are listed on the chart in the Settings Chart below.
Operation
The control uses two sensors, one located in the air stream and one located on the evaporator
coil. The sensor located in the air stream is referred to as the temperature control sensor. The
sensor located on the evaporator coil is referred to as the coil sensor.
The temperature control sensor is located inside the center tower at the top. The sensor location
is critical for proper operation on the unit. Do not move or relocate this sensor.
The coil sensor is strapped to the evaporator coil. This sensor location is critical for proper
operation of the unit. Do not move or relocate this sensor.

SELF CONTAINED

404A
VOLTAGE
32 OZ 230/60/1
34 OZ 230/60/1
36 OZ 230/60/1
AMPERAGE OPTIONAL CORD STYLE
10 15AMP NEMA 6-15
13 20AMP NEMA 6-20
13 20AMP NEMA 6-20
- 27 -

REMOTE

VOLTAGE AMPERAGE
120/60/1 10
120/60/1 13
120/60/1 14