Table of Contents
Advertisement
1. To allow access to clean upper section interior tilt the upper front glass open. Tilt the front glass up
by standing in front of the case and grabbing the handle at the bottom of the glass and lifting the
bottom of the glass upward. The glass can then be cleaned with common window cleaners.
2. Remove food pan catch tray by lifting it out of top of case. Clean all foreign material from around
and under the food pan catch tray. Clean food pan catch tray using warm soapy water and a brush.
3. If supplied with lower rear door option remove both inner & outer rear doors as described in the
"Door Removal" section of this manual.
4. Clean all foreign material from inner and outer rear door tracks and clean both sides of the doors
using warm soapy water and a brush. Apply a light film of lubricant such as PAM to door tracks to
make the doors operate smoother.
5. Remove interior shelving from unit as described in the "Shelving Installation and Removal"
section of this manual. Remove both shelf standards from interior of case by removing the (2)
thumbscrew from top and bottom of each standard.
6. Clean all shelves, shelf supports, shelf light housings, shelf brackets, shelf standards using warm
soapy water and a brush. Rinse thoroughly and allow to dry.
7. Lift the display deck(s) up and out of evaporator tub.
8. Remove the fan shroud assembly by lifting (2) black tabs up on fan shroud assembly retainer latch
at each end of the front of the fan shroud and removing the thumb screws from along the rear lip of
the fan shroud. Lift the fan shroud assembly and reach in and unplug the evaporator fan motor
cord(s). Lift fan shroud assembly out of tub.
9. Clean the display deck(s) using warm soapy water and a brush. Rinse thoroughly and allow to dry.
Wipe off fan shroud assembly (do not rinse or submerge fan motors).
Clean the entire interior of the case using warm soapy water. Flush foreign material from drain
10.
area. Wipe off all soapy water with a damp cloth and allow to dry. (DO NOT use solvents such as
Acetone, Benzene, Carbon Tetrachloride, and Lacquer Thinners)
11. Remove the honeycomb air diffuser(s) from upper air duct track. Loosen thumb screws on Retainer
located behind diffuser. Retainer will drop down allowing diffuser to be pulled out of case.
HONEYCOMB
AIR DIFFUSER
RETAINER
THUMB SCREW
12. Clean honey comb air diffuser with warm soapy water and a brush. Rinse thoroughly and allow to
dry.
13. Remove the clear plastic front air deflector by lifting it up and out of case.
IMPORTANT: Cleaning the Acrylic plastic front air deflector require special care to prevent
hazing and yellowing of material. Lightly dust (not wipe) surface with clean soft cloth. Then the
surface can be wiped carefully with a soft, wet cloth or chamois. The cloth or chamois must be
HONEYCOMB
AIR DIFFUSER
- 23 -
THUMB SCREW
RETAINER
Advertisement
Table of Contents
