Rear Doors; Bottom Section Rear Doors (Option) - FEDERAL INDUSTRIES SSRSP Series Installation & Operation Instructions

Refrigerated sandwich prep case models
Table of Contents

Advertisement

REAR DOORS (OPTION)
BOTTOM SECTION REAR DOORS (OPTIONAL)
INNER DOOR UPPER TRACK
INNER DOOR LOWER TRACK
INNER DOOR CATCH SLOT
1. LIFT UP DOOR
2 SWING BOTTOM OUT
OUTSIDE DOOR SET
1. Start with the outer outside door and lift the door upward until the bottom edge of door clears
the lower track and then swing the bottom of the door outward and down out of upper track.
2. Remove the outer inside door using the same procedure.
3. The inner door set can then be removed using the same procedure starting with the inner outside
door followed by the inner inside door.
Reverse this procedure for door reinstallation starting with the inner inside door followed by the
4.
inner outside door. Check that the doors slide freely.
Replace the outside inner door and the outside outer door. Be sure to slide the inner door catch
5.
into the inner door catch slot for each door.
Note: None of the doors are not interchangeable and they must be replaced in the same
location that they where removed from.
INNER DOOR CATCH
1. LIFT UP DOOR
2 SWING BOTTOM OUT
- 13 -
OUTER DOOR UPPER TRACK
OUTER DOOR LOWER TRACK

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ssrsp5952Ssrsp5052Ssrsp7752

Table of Contents