Table of Contents
Advertisement
Temperature Control Functions
Electronic Control
COOLING
INDICATOR
DEFROST
INDICATOR
ALARM
INDICATOR
TEMPERATURE
CONTROL KNOB
Temperature Control Knob
This controls the temperature of the display interior of case.
-OFF: Turning the control counterclockwise to the "WARM" setting is an
Off position, this position turns the refrigeration off and all indicator
lights will also be off at this setting.
-ON; The control will be on from the warmest setting at "1" and the coldest setting at
"COLD".
Cooling light
This light will be on when control requires refrigeration to be on. The compressor /
condensing unit should be running to cool the case.
Defrost light
This light will be on when control when refrigeration is defrosting allowing ice to melt
off of evaporator coil. The number of times and length of defrost will vary depending
on case environment.
Alarm light
This light indicates that there is a problem with case or electronic control and
service should be called.
Initial Start-Up
After all the checks outlined in the installation section of this manual have been made, the case is
ready to be put into service. Turn on the Power at the breaker box and flip the Power Switch and
Light Switch on unit to the on position.
At start up from a warm unit, it is recommended that the temperature control is set at a warm
setting, such as 1 on the dial. After the unit has gone through several cycles, turn the control to a
mid range setting, then to a colder setting if necessary to maintain desired product temperature
NOTICE:
This refrigerated display case is designed to operate
in a maximum environment of 75 DEG. F and 55% relative
humidity. Exceeding these limits will cause poor case
performance and excessive sweating.
- 17 -
Advertisement
Table of Contents
