Table of Contents
Advertisement
5.
Make sure that the slots in the slide
bar are aligned with the lugs in the
support and fit the two slide bar
supports to the ends of the slide bar.
Make sure that each support is pushed
firmly home.
Note! If replacing an existing Mira Slide
Bar proceed to instruction 8.
6.
Using the assembled slide bar and
supports as a template, mark the
position of the two fixing holes using
the centre slot.
Warning! Make sure that there are no
buried cables or pipes in the wall before
drilling.
7.
Drill the two 8 mm holes for the fixing
screws and insert the wall plugs
supplied. (Alternatively use proprietary
cavity fixings for dry lined, stud
partition, shower cubicle or laminated
panel walls).
8.
Fix the bottom slide bar support to the
wall using the screw provided. Make
sure that the screw is fully tightened.
9.
Loosely screw the top slide bar
support to the wall. Press firmly down
on the top slide bar support and, while
continuing to apply force, fully tighten
the screw.
10. Fit the end caps to the slide bar
supports.
11. Check the slide bar cannot be rotated
or vertically moved. If there is
movement remove the slide bar
assembly from the wall. Check the slide
bar support lugs are properly engaged
with the slots in the slide bar and the
supports are pushed fully onto the slide
bar ends. Refit the slide bar assembly.
12. Refer to sections: Handset Installation
and Soap Dish Installation to
complete the fittings installation.
9
Wall Plug
Top Slide Bar
Support
Fixing Screw
End Cap
Slide Bar
Clamp
Bracket
Assembly
Hose
Retaining
Ring
Slide Bar
Support Lug
Bottom Slide Bar
Support
End Cap
Advertisement
Table of Contents
