Installation; Slide Bar And Clamp Bracket - Mira Logic Series Installation & User Manual

Shower fittings
Table of Contents

Advertisement

Note! For dry lined, stud partition, shower cubicle or laminated panel walls the installer
may wish to obtain alternative proprietary cavity fixings. Use of these alternative
fixings is beyond the scope of this guide.
Important! If the Logic slide bar replaces an existing Mira slide bar make sure that
the position of the shower control and the shower fittings provide a minimum of 25 mm
between the handset and bath/tray spill-over level. This is necessary to prevent
back-siphonage. If this is not possible then the new slide bar will have to be
repositioned.

Slide Bar and Clamp Bracket

Read the section: Installation Requirements before proceeding with the installation.
The slide bar should be positioned to one side of the shower control at a convenient
height for all the family. It should be positioned so that the handset discharges down
the centre line of the bath, or across the opening of the shower cubicle. The handset
should be directed away from the shower control.
1.
Decide on a suitable position for the
slide bar avoiding buried cables and
pipes. Make sure that when the hose
retaining ring is placed on the lowest
position on the slide bar there is a
minimum of 25 mm between the
handset and bath/tray spill-over level.
This is necessary to prevent
back-siphonage.
2.
Important! The slide bar has been
supplied with an applicator fitted to one
end (refer to illustration) to assist the
assembly of the slide bar through the
clamp bracket.
With the clamp bracket button FULLY
depressed carefully ease the slide bar
through the hole in the clamp bracket.
Take care not to dislodge the constant
friction mechanism or the friction pad.
3.
Release the clamp bracket button.
Remove the applicator from the slide
bar and store in a safe place for future
use.
4.
Slide the hose retaining ring onto the
slide bar below the clamp bracket.

INSTALLATION

8
25 mm Minimum
Spill-over level
Clamp Bracket
Constant Friction
Mechanism and
Friction Pad
Hose Retaining
Ring
Applicator
Slide Bar

Advertisement

Table of Contents
loading

This manual is also suitable for:

Power series

Table of Contents