Table of Contents
Advertisement
Handset Installation
Caution! Do not overtighten the hose.
1.
Screw the hose onto the outlet of the
shower control (Make sure that the
hose washer is fitted).
2.
Pass the flexible hose through the
hose retaining ring and screw the
remaining end of the hose onto the
handset (Make sure that the hose
washer is fitted).
3.
Place the handset in the clamp bracket
assembly.
Soap Dish Installation
1.
Decide on a suitable position for the
soap dish, avoiding any buried cables
and pipes.
2.
Place the wall bracket on the wall and
mark the position of the fixing holes.
Warning! Make sure that there are no
buried cables or pipes in the wall before
drilling.
3.
Drill the two 8.0 mm fixing holes for
the soap dish at 35 mm centres, and
insert the wall plugs supplied.
4.
Screw the wall bracket to the wall.
5.
Clip the soap dish onto the wall bracket.
6.
This completes the installation of the
Mira Logic power shower fittings.
35 mm
Wall Plug
Wall Bracket
10
Handset
Hose
Washer
Clamp
Bracket
Assembly
Hose
Retaining
Ring
Soap Dish
Fixing Screw
Advertisement
Table of Contents
