Messages List; Warning Messages; Caution Messages - Sony VPL-DX10 Operating Instructions Manual

Messages List

Warning Messages

Use the list below to check the meaning of the messages displayed on the screen.
Message
High temp.! Lamp off in 1
min.
Frequency is out of range!
Please check Input-A
Signal Sel.
Please replace the Lamp.
Please clean the filter.
Projector temperature is
high. High Altitude Mode
should be "On" if the
projector is being used at
high altitude.

Caution Messages

Use the list below to check the meaning of the messages displayed on the screen.
Message
Not applicable!
The panel keys are locked! "Panel Key Lock" in the Function menu is set to "On."
Meaning and Remedy
The internal temperature is too high.
c Turn off the power.
c Check to see that nothing is blocking the ventilation holes.
• This input signal cannot be projected as the frequency is out of the
acceptable range of the projector.
• The resolution setting of the output signal of the computer is too
high.
c Input a signal that is within the range of the frequency.
You have input an RGB signal from the computer when "Input-A
Signal Sel." in the Setup menu is set to "Component."
c Set "Input-A Signal Sel." correctly (page 51).
• It is time to replace the lamp.
c Replace the lamp (page 58).
• If this message appears again after you replace the lamp, the lamp
replacement process is not complete.
c Perform the operations in step 9 to 12 on page 59.
Note
To erase a message, press any key on the control panel of the
projector or on the remote commander.
It is time to clean the filter.
c Clean the filter (page 60).
Note
To cancel the message, press any key on the remote commander or
the control panel of the main unit. The message is displayed twice,
including when the unit is started next time.
Internal temperature is too high.
c When using the projector at an altitude of 1,500 m or higher, set
"High Altitude Mode" on the Setup menu to "On" (page 50).
c If this message appears on the screen when using the projector
at normal altitudes, check to see if anything is blocking the
ventilation holes (exhaust) (page 17).
Meaning and Remedy
You have pressed the wrong key.
c Press the appropriate key.
c All the keys on the control panel of the projector are locked.
Operate the projector with the keys on the Remote Commander
(page 52).
65
Troubleshooting