Connecting a Computer
This section describes how to connect the
projector to a computer.
For more information, refer to the
computer's instruction manual.
To connect a computer
Rear
to INPUT A
connector
2 1
to monitor
output
Computer
A Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
B HD D-sub 15-pin cable (supplied)
Notes
• The projector accepts VGA, SVGA, XGA,
WXGA, WXGA+, SXGA and SXGA+
signals. However, we recommend that you
set the output mode of your computer to
XGA for the external monitor.
• If you set your computer, such as a notebook
For details, refer to the operating
instructions supplied with your computer.
Note
To connect a Macintosh computer equipped
with a video output connector of a type having
two rows of pins, use a commercially available
plug adaptor.
to AUDIO
connector
to audio
output
computer, to output the signal to both your
computer's display and the external monitor,
the picture of the external monitor may not
appear properly. Set your computer to output
the signal to only the external monitor.
Connecting the Projector
23