Sony VPL-DX10 Operating Instructions Manual page 26

3
Turn on the equipment connected to
the projector.
4
Move the lens shutter lever to open the
lens shutter.
5
Adjust the upper or lower position of
the picture.
Use the adjuster to adjust the picture
position.
Using the adjuster
1 Lift the projector while pressing the
Adjuster adjustment button.
2 Adjust the tilt of the projector.
3 Release the Adjuster adjustment
button.
4 When fine-tuning is necessary, turn
the Adjuster right and left.
2
Notes
• When you adjust the tilt of the projector
with the adjuster, the V keystone
adjustment is performed at the same
time. If you do not want to perform the
automatic keystone adjustment, set the
"V Keystone" to "Manual." (See
page 54.)
• If you set the "V Keystone" to "Auto,"
the "V Keystone" correction is
automatically adjusted. However, it may
not be perfectly adjusted depending on
the room temperature or the screen
angle. In this case, adjust it manually.
26
Projecting
6
7
13
4
Press the KEYSTONE key to display "V
Keystone" on the screen, and adjust the
value with the v/V/b/B keys. The
adjusted value is valid until the power is
turned off.
• Be careful not to let the projector down
on your fingers.
• Do not push hard on the top of the
projector with the adjuster extended. It
may cause a malfunction.
Adjust the size of the picture and the
focus.
Adjust the picture size using the Zoom
ring and adjust the picture focus using
the Focus ring.
Press the INPUT key to select the
input source.
Each time you press the key, the input
signal switches as follows:
Input signal indicator
VPL-DX10/DX11
Input-A Video
VPL-DX15
Input-A Network
S-Video
Input signal indicator
Shows the selected input channel.
is displayed when no signal is input. You
can hide this indicator using "Status" on
the Setup menu.
To input from
Computer connected to
the INPUT A connector
S-Video
USB
Video
x
Press INPUT
to display
Input-A