Connecting A Vcr - Sony VPL-DX10 Operating Instructions Manual

Connecting a VCR

This section describes how to connect the
projector to a VCR.
For more information, refer to the
instruction manuals of the equipment you
are connecting.
To connect to a video output
connector
Rear
to VIDEO
connector
to
S VIDEO
connector 2
to S
video
to video
output
output
A Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
B Video cable (not supplied) or S-Video cable
(not supplied)
24
Connecting the Projector
to AUDIO
connector
1
to audio
output
(L/R)
VCR
To connect to a video GBR/
Component output connector
Rear
to INPUT A
connector
2
to video
GBR/
component
output
VCR
A Stereo audio connecting cable (not supplied)
(Use a no-resistance cable.)
B Signal Cable (not supplied)
HD D-sub 15-pin (male) ↔ 3 × phono plug
Notes
• Set the aspect ratio using "Aspect" on the
Screen menu according to the input signal.
• When you connect the projector to a video
GBR output connector, select "Video GBR"
or when you connect the projector to a
component output connector, select
"Component" with the "Input-A Signal Sel."
setting on the Setup menu.
to AUDIO
connector
1
to audio
output
(L/R)