Panel Key Lock - Sony VPL-DX10 Operating Instructions Manual

Security Lock
Re-enter new password key.
Be sure to remember this password.
Use:
When "Security Lock enabled!" is
displayed on the menu screen, the
setting for security lock is completed.
If "Invalid Password!" is displayed on
the menu screen, perform this procedure
again from step 1.
6
Turn the main power off and
disconnect the AC power cord.
The security lock is set to on, then it
becomes effective. The screen used for
entering the password is displayed when
the power is turned on the next time.
Security certification
When the password screen is displayed,
enter the password that was set. If you fail to
enter the correct password after three tries,
the projector cannot be used. In this case,
press the ?/1 key to turn off the power.
To cancel the security lock
1
Press the MENU key, then set the
"Security Lock" setting to "off" in the
Function menu.
2
Enter the password.
Enter the password that was set.
Note
If you call Sony personnel because you have
forgotten the password, you will be asked to
verify the projector's serial number and your
identity. (This process may differ in other
countries/regions.) Once your identity has been
confirmed, we will provide you with the
password.

Panel Key Lock

The Panel Key Lock function enables
locking of all keys on the control panel on
the topside, which in the case only the
Remote Commander can be used.
Cancel: Other key 1
Press the MENU key.
The menu appears.
2
Press the v/V key to select the
Function menu then press the B or
ENTER key.
3
Select "Panel Key Lock" with the v/V
key from the Function menu then
press the ENTER key.
4
Select "Yes" with the b key.
Panel Key Lock comes to be valid.
If it is set to "Yes", the power can be
turned on if you hold the ?/1 key on the
control panel pressed for approximately
10 seconds during Standby mode. While
the projector enters into Standby mode if
the ?/1 key is held pressed for
approximately 10 seconds during power
on.
Panel Key Lock
Lock the control panel keys?
Yes No
Using the Security Function
35