Charging - Silvercrest SHBSP 800 A1 Operating Instructions Manual

__291948_Haarschneider_Autokamm_B8.book Seite 39 Dienstag, 19. Dezember 2017 7:42 19
5.

Charging

WARNING! Risk of material damage!
The battery must only be charged using the USB plug-in power
unit 10 supplied. Charging via the USB port of other devices is not
permitted. The devices could be damaged.
NOTES:
• The charging time for the battery is approx. 90 minutes.
• The USB plug-in power unit 10 consumes electricity for as long as it
is plugged into the wall socket. Pull the USB plug-in power unit 10
out of the wall socket to disconnect the device from the mains.
• The capacity/charging state of the battery 16 is displayed in per-
cent (5, 10, ... ,100% in increments of 5%).
• When the battery is almost flat, the red plug symbol 19 flashes. The
device can then only be used for a short time without being connect-
ed to the electricity supply.
• When the battery is fully charged, the device can be used for ap-
prox. 60 minutes without being connected to the power supply.
• In order to increase the service life of the battery, we recommend us-
ing the device regularly and without extended storage periods.
1. Switch off the device with the on/off switch 7 if necessary.
2. Insert the larger plug of the USB cable 9 into the USB port at the
USB plug-in power unit 10.
3. Insert the small plug of the USB cable 9 into the micro USB port 8 at
the hair and beard trimmer 4.
4. Insert the USB plug-in power unit 10 into an easily accessible wall
socket, the voltage of which corresponds to the rating plate of the
USB plug-in power unit. The wall socket must continue to be easily
accessible after the device is plugged in.
5. The red plug symbol 19 is lit and the battery is charged. When the
battery is fully charged, 100% is displayed and the plug symbol 19
goes off.
39
GB