Advertisement
Telecom / Intercom Link
ComPack also functions as a simple "no-frills" telecom link for your beltpack
intercom system. ComPack will provide bi-directional audio on pin 3 of the male
XLR jack to any industry standard intercom beltpack system. ComPack does not
provide power over this XLR jack nor does it require power from the loop.
Note: ComPack will not recognize a call signal generated by your intercom
system and it will not provide one.
1.
Slide the Male XLR selector switch to the <Intercom Link> position. This
recessed switch is located near the power jack. Accessing the switch can be
done using a small blade screwdriver, or other such object, inserted into the
opening. The left position (towards the XLR jacks) designates Line Output.
The right position (towards the volume controls) designates Com Link. The
factory default position of this switch is Line Output.
2.
Connect your beltpack intercom XLR cable to the ComPack
<Mix Out / Com Link> jack. The XLR jack is wired as:
Pin 1: Ground
Pin 2: Open
Pin 3: Two-Way Audio
3.
Your intercom headset should remain plugged in to your beltpack system,
not directly into ComPack.
Getting Connected
7
Advertisement
Need help?
Do you have a question about the ComPack and is the answer not in the manual?
Questions and answers