Connecting Two Vcrs For Tape Editing - Sony KF-42WE620 Service Manual

Installing and Connecting the LCD Projection TV

Connecting Two VCRs for Tape Editing

VCR (playback)
A/V cable (not supplied)
36
If you connect two VCRs, you can record from one VCR to the other while
using your LCD projection TV to monitor what is being recorded.
Disconnect all power sources before making any connections.
1
Using A/V cables, connect the playback VCR's AUDIO/VIDEO OUT
jacks to the recording VCR's AUDIO/VIDEO IN jacks.
2
Using A/V cables, connect the recording VCR's AUDIO/VIDEO OUT
jacks to the LCD projection TV's AUDIO/VIDEO IN jacks.
To perform tape editing, set the LCD projection TV to the video input
intended for playback by pressing TV/VIDEO on the remote control.
You may need to change the video input on your VCR. Consult your
VCR's operating manual for instructions.
If your VCRs have S VIDEO jacks: For best picture quality, use an
S VIDEO connection instead of the yellow video cable on your combined
A/V cable.
Using an S VIDEO cable, connect the playback VCR's S VIDEO OUT jack
to the recording VCR's S VIDEO IN jack. S VIDEO does not provide audio,
so audio cables must be connected to provide sound.
You cannot record signals from equipment connected to the Y, P
input.
Rear of LCD projection TV
VCR (recording)
AUDIO-R (red)
AUDIO-L (white)
VIDEO (yellow)
A/V cable (not supplied)
, P
B R