Cutting Hairlines And Beard - Silvercrest SRRP 3.7 A1 Operating Instructions Manual

NOTES:
• Shaving is possible both in battery mode and in mains oper-
ation.
• Initial use may cause temporary irritation or redness of the
skin, as the skin has to adjust to shaving. This is normal and
usually lasts between 2 to 4 weeks.
• Hold the blade unit 5 parallel to the surface of the skin, and
gently move it over your face using circular motions.
• Shave against the direction of your beard growth.
• Stretch your skin in complicated areas, such as the chin, to
achieve better results.
• Switch off the device after shaving, clean the parts carefully
(Chapter "Cleaning and care" on page 18) and to protect
the shaving heads 5, slide the protective cap 17 onto the
shaving attachment 6 from below.

6.6 Cutting hairlines and beard

WARNING! Risk of injury!
The points of the beard trimmer attachment 3 are sharp.
Handle with care.
• Figure C: adjust the cutting length at the comb attach-
ment 1 according to the desired hair length. Read the cut-
ting length on the side of the comb attachment 1 at the
marking 2. The arrow symbol
length is set. Now, shorten your beard step-by-step.
NOTE: ensure that the comb attachment 1 is still firmly attached
to the device after adjustment.
16
GB
18 indicates which cutting