Silvercrest SRRP 3.7 A1 Operating Instructions Manual page 10

Should liquid enter the device, have it checked before start-
ing the device up again.
If the device is used in a bathroom, the power unit must be
pulled out after use, as the proximity of water represents a
hazard, even when the device is switched off.
Installation of a residual current device (FI/RCD) with a rat-
ed residual operating current of no more than 30 mA is rec-
ommended to provide additional protection. Ask your
electrician for advice. The installation should only be carried
out by a qualified electrician.
DANGER! Risk of electric shock
Do not start using the device if the device, the battery charg-
er or the plug-in power unit show visible damage, or if the
device has previously been dropped.
Connect the plug-in power unit to the device/battery charger
before plugging it into a wall socket.
Lay the cable of the plug-in power unit such that no one can
step on it, get caught on it, or trip over it.
Only connect the plug-in power unit to a properly installed
easy to access wall socket which supplies voltage matching
the rating plate. The wall socket must continue to be easily
accessible after the device is plugged in.
Ensure that the cable of the plug-in power unit cannot be
damaged by sharp edges or hot surfaces. Do not wrap the
cable around the device (risk of cable damage!)
Ensure that the cable is not trapped or crushed.
When removing the plug-in power unit from the wall socket,
always pull the plug-in power unit and never the cable.
8
GB