Trimming A Beard - Silvercrest SHBS 3.7 C1 Operating Instructions Manual

• First, start with a comb attachment 2 with a longer cutting
length and then, in the course of the cutting process, use
shorter cutting lengths step by step.
• Start by cutting the hair in the neck or on the sides and cut
towards the centre of the head. Then, cut the front section of
the hair towards the centre of the head.
• Hold the hair and beard trimmer 5 in such a way that the
comb attachment 2 lies as flat as possible on the head.
Move the device evenly through the hair.
• If possible, cut against direction of hair growth.
• In order to catch all the hair, move the hair and beard trim-
mer 5 several times through each section of the hair.
• Comb the hair repeatedly and well.
• In order to achieve a straight cutting line for cutting lengths
over 12 mm, the hair and beard trimmer 5 should be passed
through the hair several times from different directions.

6.5 Trimming a beard

Beard trimmer attachment
NOTE: please note that the cutting lengths will only be achieved
if the switch for cutting length fine tuning 6 is at position 1 and
the hair and beard trimmer 5 is held at a right angle to the skin
surface.
• Comb the beard in the direction that it grows.
• Trim the beard downwards from ear to chin. First trim one
side, then the other.
• Comb attachment 1
Figure C: adjust the cutting length with the slider according
to the desired hair length and read off the cutting length us-
14
GB
14