Cutting Contours And Beard Trimming - Silvercrest SHBS 500 E4 Operating Instructions Manual

Cutting contours and beard trimming

WARNING!
The cutting blade of the shaving head
and never touch the cutting blade with your fingers.
Note
► Only cut dry hair with the appliance.
► Depending on the cutting angle, the cutting length can vary from the
setting on the comb attachment
► Make sure that the comb attachment
1
ing head
♦ Set the cutting length to the desired hair length on the comb attach-
0/q
ment
attachment
or downwards (see fig. 3). You can read the cutting lengths via the
markings on the comb attachment
your beard in stages.
Note
Press the upper side of the button, when you push the comb attachment
0/q
upwards or downwards (see fig. 5). This makes it easier to
release the comb attachment
♦ You can use the appliance without the comb attachment
with only the shaving head
your beard and contours. In this way, you can cut the hair evenly
down to 1–2 mm.
SHBS 500 E4
after adjustment.
. To do this, press the button on the back of the comb
0/q
and push the comb attachment
0/q
1
1
is sharp. Handle it carefully
0/q
.
0/q
sits firmly on the shav-
0/q
(see fig. 4). Now trim
from the catch and move it.
) to cut your hair very short or to cut
0/q
upwards
0/q
(i.e.
│
GB│IE
17 ■