Table of Contents
Advertisement
Available languages
Available languages
•
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
•
For cleaning the housing, only use a soft clean
cloth. Never use any liquid; it may get inside
the hazer and cause damage.
•
No guarantee claims for the hazer and no
liability for any resulting personal damage or
material damage will be accepted if the hazer
is used for other purposes than originally in-
tended, if it is not correctly installed or oper-
ated, or if it is not repaired in an expert way.
If the hazer is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment.
1.1 Safety instructions
•
The hazer is designed for indoor operation;
only set it up at suitable places. Poor ventila-
tion may overload the fuse so that the hazer
will not heat up.
•
Only operate the hazer in a horizontal posi-
tion; never operate it in an inclined position
or upside down.
•
Always disconnect the mains plug after use.
•
The hazer is not watertight. If haze or fog fluid
gets inside the hazer, immediately disconnect
the mains plug and contact your retailer.
•
The hazer must only be reset or repaired by
skilled technicians.
2 Before Operation
2.1 Unpacking the hazer
Open the package and make sure that it contains
all parts required for correct operation. Check the
parts for any damage which may have occurred
during transport.
If you notice any defects, do not operate the
hazer. Contact your retailer.
The following parts should be included:
– hazer
– mains cable
– instruction manual
2.2 Assembling the hazer
1) After unpacking the hazer, make sure to re-
move any packing material. Also remove any
packing material from the nozzle of the hazer.
2) Use the hose (6) to connect the tank and the
hazer (see figure on the following page).
2.3 Setting up the hazer
•
This hazer is designed for adult use only; keep
it out of the reach of children.
•
Only operate the hazer in well-ventilated
places. Do not cover the hazer to avoid heat
accumulation: Risk of fire!
•
The haze produced by the hazer is very hot
and may cause burns; therefore, always keep
a sufficient distance (minimum 0.5 m) to the
haze output nozzle.
•
Hazers develop condensation around the haze
output nozzle. When selecting a mounting
place, take into account that moisture will
accumulate below the nozzle.
•
Do not place the hazer directly on carpeted
floors or wooden floors. Make sure to keep
a minimum vertical distance of 50 cm to such
floors.
1) Set up the hazer on a flat horizontal surface. If
the hazer can only be suspended, carefully at-
tach the hazer to the mounting bracket (item
1 in the figure on page 12).
2) Make sure that the area is well-ventilated and
that there is no flammable or explosive mate-
rial within a radius of 3 m. Always operate the
hazer in a horizontal position, never operate it
in an inclined position or on its side.
WARNING!
Install the hazer safely and expertly. When in-
stalling it at a place where people may walk
or sit under it, additionally secure it, e.g. via a
safety rope attached to the eyebolt (item 10 in
the figure on page 12). Fasten the safety rope
in such a way that the maximum falling distance
of the hazer will not exceed 20 cm.
11
Advertisement
Chapters
Table of Contents
