Filling The Tank With Fog Fluid; Operation; Operating Elements And Connections - IMG STAGELINE FM-600H Instruction Manual

2.4 Filling the tank with fog fluid

1) Before filling the tank with fog fluid, switch off
the hazer and disconnect the mains plug. Do
not spill any fluid and make sure that fluid will
not get inside the hazer: Risk of short circuit!
2) Place the hazer on a flat surface. Remove the
tank and open it. Fill the tank with suitable
fog fluid. To prevent contamination of the
fluid, immediately close the tank after filling it.
•
For a perfect performance with excellent light
effects, always use special fog fluid. Thus, the
haze will be very fine and consequently very
long-lasting.
•
Never fill the tank with highly flammable fluids
such as oil, gas or fragrances.
•
The following fog fluids suitable for the hazer
are available from IMG STAGELINE in 5-litre
containers:
Item Effect
NF-502L long-lasting haze effect
extra long-lasting
NF-502SL
haze effect
WARNING!
We will not accept any liability for correct op-
eration when other fog fluids than the ones
recommended are used. Fog fluids are non-
toxic water-based fluids specifically developed
for fog machines / hazers.
Unsuitable fluids or other fluids than the
ones recommended may clog the heat-resistant
tube or cause other failures.
•
Always keep an eye on the fluid level. Imme-
diately switch off the hazer when the tank
is empty.
12

3 Operation

3.1 Operating elements and
connections
1
2
3
4
Order No.
38.1820
38.1830
1 Mounting bracket
2 Power switch (ON / OFF)
3 Air vents
4 Mains connection (230 V/ 50 Hz)
5 Touchpad
6 Hose
7 Quick connector for hose
8 Connections for DMX input / output
(XLR, 3-pole and 5-pole)
9 Tank
10 Eyebolt
11 Haze output nozzle
12 Adjustable flap
10
11
12
5
6
7
8
9