Krups EA86 Manual page 40

MALFUNCTION/PROBLEM
There is some water or coffee under
the appliance.
The application fails to connect or
frequently disconnects
The application does not detect the
machine
The logo is displayed
After having filled the water reservoir,
the warning message is still displayed
on the screen.
The machine is not requesting a
descaling cycle.
The machine requests that the coffee
grounds tray and the drip tray be
emptied when they are not full.
There is some ground coffee in the
drip tray.
Never open the appliance. Warning, mortal danger due to electrical current! Any unauthorised opening of the
appliance voids the guarantee. Don't use the appliance if it is not operating properly or if it has been damaged.
In such cases, it is advised to have the appliance examined by a centre authorised by KRUPS (review the list
in KRUPS Service booklet).
38
CORRECTIVE ACTIONS
The drip tray has overflowed: empty it and clean the coffee drawer
Check the proper positioning of the drip tray.
Do not remove the water reservoir before the recipe's completion.
Check that the machine's Bluetooth BLE module is not deactivated.
Come as close as possible to the machine when using the application.
Close and re-open the application.
Unplug the appliance for 20 seconds, remove the Claris Aqua Filter
System cartridge if present, and then put it into operation again.
If the defect persists, contact the KRUPS Consumer Service
Department.
Check that the reservoir is properly positioned in the appliance. The
float at the bottom of the reservoir must move freely. Check the float
and unblock it, if necessary.
The descaling cycle is requested based on a significant number of uses
of the steam circuit.
The machine is programmed to request that the coffee grounds tray and
the drip tray be emptied after a certain number of coffees, irrespective
of the any intermediate emptying that you may have performed.
Small quantities of ground coffee may be deposited in the drip tray.
.
(1)