Download Print this page

Monitor Connection - Nokia 447PRO Service Manual

Chassis 447r 17" high resolution colour monitor
Hide thumbs

Advertisement

1.6. Monitor Connection

Make sure that the monitor is disconnected from mains and the power switches of
the computer and all attached devices are turned off before connecting the monitor.
-
Connect the signal cable plug to the videocontroller connector at the back of the computer.
-
Tighten the screws on the plug by hand.
-
Connect the power cord first to the monitor and then to a grounded power outlet.
1.4.1. If your monitor is DDC compatible (PC)
-
Do not use any adapter when connecting signal cable to your computer.
-
Do not extend the signal cable with extension lead. The DDC signals will not accept extended
cable.
1.4.2. If there is no DDC in your computer (PC)
-
Normally there is no need for adaptor when connecting signal cable to your computer.
-
Use MAC adaptor in signal cable when connecting the monitor to an Apple
Macintosh computer.
-
If the computer is equipped with separate display adapter card. It may have a standard
D ---SUB connector. In that case MAC adaptor is not needed.
Signal connector
Pin
Signal
1
--->
RV
2
--->
GV
3
--->
BV
4
< ---
ID2
5
6
RG
7
GG
8
BG
9
--->
10
LG
11
< ---
ID0
12
< ---
SDA
13
--->
Hs
14
--->
Vs
15
< ---
SCL
10
Red video
Green video
Blue video
(grounded)
Signal cable plugged/unplugged
Red ground
Green ground
Blue ground
DDC +5V
Logic ground
(Grounded)
DDC SDA
Horizontal sync., Composite sync.
Vertical sync.
DDC SCL
447R
5
1
6
10
11
15

Hide quick links:

Advertisement

loading

  Related Manuals for Nokia 447PRO