Monitor Connection; Signal Connector - Nokia 800Xi Service Manual

2.3. Monitor Connection

Make sure that the monitor is disconnected from mains and
the power switches of the computer and all attached devices
are turned off before connecting the monitor.
1. Connect the signal cable plug to the videocontroller con-
nector at the back of the computer.
2. Tighten the screws on the plug by hand.
3. Plug the operating voltage connector
4. Connect the power cord to the power unit.
5. Connect the power cord to a power outlet.
If your monitor is DDC compatible (PC)
- Do not use any adapter when connecting signal cable to
your computer.
- Do not extend the signal cable with extension lead. The DDC
signals will not accept extended cable.
If there is no DDC in your computer (PC)
- Normally there is no need for adaptor when connecting sig-
nal cable to your computer.
- Use MAC adaptor (QK1520) in signal cable when
connecting the monitor to an Apple Macintosh computer.
- If the computer is equipped with separate display adapter
card. it may have a 3 x 5 pin D--SUB connector. In that
case MAC adaptor is not needed.

Signal connector

Pin Signal
1 RV
- ->
2 GV
- ->
3 BV
- ->
4 <- - ID2
5
6 RG
7 GG
8 BG
9
10 LG
11 <- - ID0
12 <- - SDA
13 Hs
- ->
14 Vs
- ->
15 <- - SCL
10
Red video
Green video / Sync on green
Blue video
Monitor Identification (LG)
Red ground
Green ground
Blue ground
Logic ground
Monitor Identification (LG)
DDC SDA
Hor. sync. / Composite sync.
Vert. sync.
DDC SCL
456A
5
4
1 5
6 11 10 15
3
2
1
MAC adaptor