RAB Lighting LFLED Series Installation Instructions

LFLED INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We'd like to hear your comments. Call
the Marketing Department at 888-RAB-1000, or email: marketing@rabweb.com
IMPORTANT
READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE
RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper
grounding is required for safety. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE
INSTALLATION CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
Make certain power is OFF before installing or maintaining fixture. No user serviceable
WARNING:
parts inside.
WALL MOUNTING
Mount to a weatherproof junction box and cover plate
(not supplied) as shown. To ensure weatherproof seal,
apply weatherproof silicone sealant around the edge of
the wall cover plate or surface box. This is especially
important with an uneven wall surface.
1. Seal arm thread using Teflon tape or silicone sealant.
2. Thread fixture into Cover Plate(not supplied).
3. Connect wires as shown in the wiring diagram.
4. Attach cover plate to Junction Box (not supplied).
5. Aim floodlight in the direction desired and tighten
locknut and Arm Screw.
Arm Screw
Junction Box
(not supplied)
Cover Plate
(not supplied)
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
LF Flood LF Spot
GROUND MOUNTING
Mount to a Mighty Post (RAB Cat# MP19) as shown.
1. Thread fixture into Mighty Post Cap.
2. Connect wires as shown in the wiring diagram and
place inside the Mighty Post.
3. Place Mighty Post Cap on the Mighty Post.
4. Aim floodlight in the direction desired and tighten
locknut and Arm Screw.
.
Arm Screw
Mighty Post
Cap
Mighty Post