Wildix W-AIR Series User Manual page 4

W-AIR DECT Handset - User Guide
1 x Handset with Lithium-Ion battery
1 x charger
1 x A/C adapter
1 x belt clip and belt clip cover
W-AIR Office:
1 x Handset with Lithium-Ion battery
1 x charger
1 x A/C adapter
1 x belt clip and belt clip cover
Compatible headsets:
Wildix headsets: http://www.wildix.com/voip-phones-and-headset/#headsets
Third party headsets integrated with Wildix:
Axtel .
Safety information
Using the battery
Never dispose of the battery in fire, otherwise it could explode
Never replace the battery in potentially explosive environments, for example close to inflammable liquids
/gases
Use ONLY approved batteries and chargers from the vendor or the operator
Do not disassemble, open or damage the battery, use it carefully to avoid a short circuit
Using the Charger
Input Voltage: 110-240VAC; Output Voltage 5.5VDC / 600mA.
For the best performance, charge the handset for at least 10 hours the first time.
When charging, make sure that the room temperature is between 0°C and 25°C / 32°F and 77°F.
Do not leave the handset in direct sunlight when charging. The battery has a built-in heat sensor that stops the
charging when the temperature is too high.
There is a charging status indicator on the phone display.
Before using the phone, carefully read the safety information:
Put into operation
W-AIR Basic:
1. Open the battery compartment by pressing the battery cover and sliding it
2. Remove the battery cover, insert the batteries and close the battery compartment
3. Place the phone into the charger and fully charge the battery; for the best performance, charge the
handset for at least 10 hours the first time (charging status is indicated on the display)
W-AIR 100 (End Of Life):
1. Open the battery compartment by pulling the latch
2. Lift the battery cover and remove the battery
3.
W-AIR DECT Handset - User Guide
Wildix Compatible Headsets – Jabra, Plantronics, Sennheiser, JPL,
https://www.wildix.com/safety-information/
.
Page 4 of 23