Table of Contents
Advertisement
SANTA FE PELLET INSERT
F. Panel and Trim Set
1. Lay panel top and legs face down on protective
covering to prevent scratching.
2. Attach the panel legs to the top panel using a Phillips
head screwdriver. There are 2 screws for each leg
(Figure 22.2).
3. Open the hopper lid by pulling toward you. This will
make it easier to set the panels in place. Secure the
panels to the insert, 2 screws per leg, as shown in
Figure 22.3.
4. Connect the trim pieces together using the "L" Brackets
supplied (Figure 22.4).
5. Slide the trim over the top of the panels.
6. Install the access panels. At the bottom of the access
panel there are 2 hooks that slip into a slot at the
bottom of the side panel and a magnet at the top that
holds the access panel in place (Figure 22.3).
Figure 22.1 - Completed View
Attach panel
legs to top
Figure 22.2
22
Open Hopper Lid for
Easier Placement of
Panel Set
Access Panels
Figure 22.3
Figure 22.4
7019-801C
Magnet
Side
Panel
Hook
Access Panel
July 10, 2019
Advertisement
Table of Contents
