Table of Contents
Advertisement
SANTA FE PELLET INSERT
6
Appliance Set-Up
A. Leveling System
The leveling bolts are located at the rear of the appliance.
To access the bolts, remove the front access panels.
Reach in and turn the bolt to the desired height to level the
appliance (Figures 20.1).
Leveling Bolt on Each Side
Figure 20.1
B. Door Handle Removal
1. Open the door. Using a 5/32 Allen wrench, loosen set
screw by a couple of turns, but do not remove.
2. Push the pin completely out and remove the handle.
3. Re-install in reverse order.
C. Door Removal
1. Remove the door handle and face. Follow instructions
from B above.
2. The door can now be lifted off the hinges.
3. Re-install in reverse order.
20
D. Outside Air Kit Instructions
1. Measure distance from floor to air vent opening in
appliance and mark location on wall.
2. Use saw to cut opening in wall. Cut a 2-1/2 to 3 inch
(64-76mm) opening on inside wall and a 3 to 3-1/2 inch
(76-89mm) opening on outside of house.
3. Use hose clamp to secure flex pipe to collar assembly
(Figure 20.2).
4. Slide trim ring over flex pipe and run pipe through wall.
5. Attach hose to outside termination cap with second
hose clamp.
6. Secure termination cap to outside surface.
7. Secure trim ring to interior wall.
Never draw outside combustion air from:
•
Wall, floor or ceiling cavity
•
Enclosed space such as an attic or garage
2 inch diameter
Flex Pipe
Figure 20.2
7019-801C
CAUTION
Attach Termination
Cap to Exterior Wall
July 10, 2019
Advertisement
Table of Contents
