Table of Contents
Advertisement
Figure 40 Backup Data
Figure 41 Micro USB female connector
Figure 42 Delete GLP
Backup Data
→
Backup Data
This function allows you to backup logged data to a flash drive based on
Site, Data ID, and log date
adapter is included with new instruments for this data backup.
NOTE: The USB storage device must be formatted as FAT32, not
NTFS or exFAT. The handheld will only support FAT32.
If the box next to "Include Sensor Info" is checked, each data set will
be sent to a flash drive as a separate file with sensor serial number and
sensor software information included. If the box is not checked (default),
all data sets will be sent in a single backup file with no sensor serial
number or sensor software information.
NOTE: It is suggested to send data to the USB flash drive as
a single file (i.e. box is not checked) unless this sensor
information is needed. This makes importing the data much
faster and easier.
Once the filter settings are configured, select Backup Data to send the
data to a flash drive.
NOTE: The data is exported in a CSV file.
NOTE: If the data backup is not successful, ensure the correct filter
criteria are selected and the USB connection indicator can
be seen at the top of the screen
Delete GLP
→
Delete GLP
To permanently delete the GLP file from the instrument, select Yes, then
ENTER
push the
key
(Figure
(Figure
40). A USB female to micro USB male
(Figure
42).
Operation
9).
31
Advertisement
Table of Contents
