Table of Contents
Advertisement
Operation
Figure 33 GPS
Calibration menu
Cal
Push the
key to access the Calibration menu
sub-menu options.
Pre-defined or user-selected parameters are noted within brackets ([]). See
Refer to the Calibration section for sensor specific calibration procedures
NOTE: Attached sensors are listed according to the bulkhead port in which they are installed.
NOTE: User ID, Probe ID, and User Field #1 and #2 must be enabled in the GLP menu to appear in the Calibration
menu
("GLP Options" on page
1 Sensors connected to bulkhead
2 Optional Depth sensor calibration
3 Barometer calibration
4 Restore Default Calibration - restores
all calibrations to factory default
28
GPS (Optional)
→
GPS
GPS turns the ProDSS Global Positioning System On or Off. The
symbol is shown when a GPS signal is received
When enabled, the GPS coordinates will be saved with the GLP file and
logged data.
NOTE: GPS data will be most accurate when there is a clear line of sight
to satellites. GPS will not typically receive a signal while inside a
building.
(Figure
17).
1
2
3
4
5
6
7
Figure 34 Calibration menu
34). Highlight a sub-menu then push the
"Alpha/numeric entry" on page
("Calibration" on page
5 User ID
6 Probe ID
7 User Field #1
(Figure
33).
ENTER
key to view
14.
33).
Advertisement
Table of Contents
