Table of Contents
Advertisement
Operation
Figure 21 Display Brightness
Sensor Menu
Use the Probe
key to access the Sensor menu and change sensor settings (if applicable), enable the measurement
units displayed on the Run screen, set Auto Stable parameters, change the sensor averaging mode, and if equipped,
turn on/off GPS.
Figure 22 Probe (Sensor) menu
22
Unit ID
→
Unit ID
Unit ID identifies the instrument in the KorDSS PC software program that
was included with the instrument.
Select Unit ID to change the default ID.
Sensor Info
→
Sensor Info
Sensor info shows measurement data, and hardware/software information
for each component of the system: instrument, sensor, and bulkhead. Use
the
and
arrow keys to scroll through the components.
Brightness
→
Brightness
The screen brightness can be adjusted to accommodate lighting
conditions and to conserve battery power
Select Brightness then use the
brightness.
NOTE: In bright conditions, set the screen brightness to 75% or
greater.
Push the
key to access the sensor menu
ENTER
menu then push the
Pre-defined or user-selected sensor settings are noted within brackets ([]).
(Figure
and
arrow keys to adjust the screen
(Figure
key to view sub-menu options.
21)..
22). Highlight a sub-
Advertisement
Table of Contents
